Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
Our Kimberly, WI drying plans start with thermal imaging to map exactly where moisture is hiding.
Every Structural Drying And Dehumidification job in Kimberly, WI starts with psychrometric calculations that determine exactly how much airflow and dehumidification capacity is needed.
LGR capacity is standard equipment on every Structural Drying And Dehumidification job, not a premium upgrade.
Thermal imaging cameras reveal moisture patterns behind walls and under flooring that aren't visible to the eye.
Moisture readings are logged daily throughout the Structural Drying And Dehumidification job so progress is measurable, not assumed.
Below is the calculated, documented process our Kimberly, WI teams follow.
The assessment sets the baseline every later reading gets measured against.
Thermal imaging often reveals moisture has traveled further than the visible damage suggested.
Equipment is placed according to calculated airflow paths, not an even spread across the room.
Daily monitoring confirms equipment is working and adjusts the plan if progress stalls.
We adjust drying speed for sensitive materials like hardwood and cabinetry to prevent secondary damage.
Final verification compares closing readings against the material-specific dry standard, not a general guess.
We ask enough to bring the right instruments on the first visit.
Our nearest Kimberly, WI crew brings diagnostic equipment loaded from the start.
We complete the psychrometric assessment and thermal scan, then provide a written drying plan and quote.
We verify final moisture readings against dry standard before removing equipment.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
We rely on moisture meters and thermal imaging, not appearance alone.
It's a calculated approach using temperature and humidity data to determine exact equipment needs, rather than guessing.
Typical drying time is 3-5 days for standard materials, longer for sensitive ones like hardwood.
Daily documentation is standard, giving you real data rather than just an assurance.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
A stall in the daily logs triggers a plan review rather than simply leaving equipment running unchanged.
If your property is in or near Kimberly, a crew can typically respond the same day.
One call starts the psychrometric assessment process.
Call +1-844-833-1325